MCP1416T-E/OT

LS: IC MOSFET DVR 1.5A HS TSOT23-5
развернуть ▼ свернуть ▲
 

Технические характеристики

показать свернуть
Корпус SOT235
Кол-во нижних каналов
Кол-во верхних каналов
Максимальный выходной ток нарастания
Опции IC MOSFET DVR 1.5A HS TSOT23-5
Рабочая температура
Примечание
Нашли ошибку? Выделите её курсором и нажмите CTRL + ENTER

Аналоги 1

показать свернуть
Тип Наименование Корпус Упаковка i Nнижн Nверхн Uoffset Iout+ Iout- Uизол Опции T раб Примечание Карточка
товара
F~ 1EDN7512BXTSA1 (INFIN) SOT235 в ленте 3000 шт Rail-to-rail выход, защита UVLO 4,2В Устойчивость к входному напряжению до -10 В, встроенная защита от обратного тока до 5А

Файлы 1

показать свернуть
MCP1415/16 Tiny 1.5A, High-Speed Power MOSFET Driver Features General Description • High Peak Output Current: 1.5A (typical) • Wide Input Supply Voltage Operating Range: - 4.5V to 18V • Low Shoot-Through/Cross-Conduction Current in Output Stage • High Capacitive Load Drive Capability: - 470 pF in 13 ns (typical) - 1000 pF in 20 ns (typical) • Short Delay Times: 41 ns (tD1), 48 ns (tD2) (typical) • Low Supply Current: - With Logic ‘1’ Input - 0.65 mA (typical) - With Logic ‘0’ Input - 0.1 mA (typical) • Latch-Up Protected: Will Withstand 500 mA Reverse Current • Logic Input Will Withstand Negative Swing Up To 5V • Space-saving 5L SOT-23 Package The MCP1415/16 are high speed MOSFET drivers capable of providing 1.5A of peak current. The inverting or non-inverting single channel output is directly controlled from either TTL or CMOS (3V to 18V) logic. These devices also feature low shoot-through current, matched rise and fall time, and short propagation delays which make them ideal for high switching frequency applications. Applications • • • • • Switch Mode Power Supplies Pulse Transformer Drive Line Drivers Level Translator Motor and Solenoid Drive The MCP1415/16 devices operate from a single 4.5V to 18V power supply and can easily charge and discharge 1000 pF gate capacitance in under 20 ns (typical). They provide low enough impedances in both the on and off states to ensure the intended state of the MOSFET will not be affected, even by large transients. These devices are highly latch-up resistant under any condition within their power and voltage ratings. They are not subject to damage when up to 5V of noise spiking (of either polarity) occurs on the ground pin. They can accept, without damage or logic upset, up to 500 mA of reverse current being forced back into their outputs. All terminals are fully protected against Electrostatic Discharge (ESD) up to 2.0 kV (HBM) and 400V (MM). Package Types: SOT-23-5 MCP1415 NC 1 MCP1416 5 OUT OUT 4 GND GND VDD 2 IN 3 MCP1415R MCP1416R NC 1 5 VDD VDD 4 OUT OUT GND 2 IN 3 © 2008 Microchip Technology Inc. DS22092C-page 1 PDF
Документация на MCP1416T-E/OT 

Tiny 1.5A, High-Speed Power MOSFET Driver High-Speed Power MOSFET Driver

Дата модификации: 18.12.2008

Размер: 316.9 Кб

20 стр.

    Внимание! Точность указанного на сайте описания товара не может быть гарантирована. Для получения более полной и точной информации о товаре смотрите техническое описание (Datasheet) на сайте производителя.