SPBTLE-1S

Key Features Bluetooth v4.2 compliant Supports master and slave modes Multiple roles supported simultaneously High performance, ultra-low power Cortex-M0 32-bit based architecture core Programmable embedded 160 KB Flash 24 KB embedded RAM with data retention Interfaces: 1 x UART, 2 x I²C, 1xSPI, 14 x GPIO, 2 x multifunction timer, 10-bit ADC, Watchdog & RTC, DMA controller, PDM stream processor, SWD debug Interface Bluetooth radio performance: Max Tx power: + 5 dBm Excellent link reliability On-board chip antenna Small form factor: 11.5 mm x 13.5 mm Complemented with Bluetooth low energy protocol stack library (GAP, GATT, SM, L2CAP, LL) AES security co-processor Bluetooth low energy SDK with wide range of profile available Certifications: EU (RED) Type certificate FCC, IC modular approval certification SRRC Chinese Certification BT SIG End Product QDID Pre-programmed UART bootloader Operating supply voltage: from 1.7 to 3.6 V Operating temperature range: -40 °C to 85 °C
развернуть ▼ свернуть ▲

Технические характеристики

показать свернуть
Конструктивное исполнение
Рабочая частота
Режим работы
Стандарт передачи данных
Версия стандарта протокола
Поддерживаемые интерфейсы 1 x UART, 2 x I²C, 1xSPI, 14 x GPIO, 10-bit ADC
Скорость передачи данных (макс)
Напряжение питания
Ток потребления
Мощность передатчика
Наличие встроенной антенны или антенного разъёма
Чувствительность приёмника
Размер 11.5×13.5×2 мм
Рабочая температура
Нашли ошибку? Выделите её курсором и нажмите CTRL + ENTER

Файлы 1

показать свернуть
SPBTLE-1S Very low power application processor module for Bluetooth® Low Energy v4.2 Datasheet - production data     FCC, IC modular approval certification  SRRC Chinese Certification  BT SIG End Product QDID Pre-programmed UART bootloader Operating supply voltage: from 1.7 to 3.6 V Operating temperature range: -40 °C to 85 °C Applications Features             Bluetooth v4.2 compliant  Supports master and slave modes  Multiple roles supported simultaneously High performance, ultra-low power CortexM0 32-bit based architecture core Programmable embedded 160 KB Flash 24 KB embedded RAM with data retention Interfaces:  1 x UART, 2 x I²C, 1xSPI, 14 x GPIO, 2 x multifunction timer, 10-bit ADC, Watchdog & RTC, DMA controller, PDM stream processor, SWD debug Interface Bluetooth radio performance:  Max Tx power: + 5 dBm  Excellent link reliability On-board chip antenna Small form factor: 11.5 mm x 13.5 mm Complemented with Bluetooth low energy protocol stack library (GAP, GATT, SM, L2CAP, LL) AES security co-processor Bluetooth low energy SDK with wide range of profile available Certifications:  EU (RED) Type certificate October 2017           Internet of Things Smart Home Building and Industrial Automation Smart Lighting Remote and access control Fitness, wellness and sports Consumer medical Security and proximity Assisted living PC and smart phone peripherals Description The SPBTLE-1S is a Bluetooth® low Energy System-on-Chip application processor certified module, compliant with BT specifications v4.2 and BQE qualified. The SPBTLE-1S module supports multiple roles simultaneously and can act at the same time as Bluetooth Smart master and slave device. The SPBTLE-1S is based on BlueNRG-1 systemon-chip and entire Bluetooth Low Energy stack and protocols are embedded into module. The SPBTLE-1S module provides a complete RF platform in a tiny form factor. Radio, embedded antenna and high frequency oscillators are integrated to offer a certified solution to optimize the time to market of the final applications. The SPBTLE-1S can be powered directly with a pair of AAA batteries or any power source from 1.7 to 3.6 V. DocID030445 Rev 3 This is information on a product in full production. 1/27 www.st.com PDF
Документация на SPBTLE-1S 

Very low power application processor module for Bluetooth® Low Energy v4.2

Дата модификации: 26.10.2017

Размер: 923.6 Кб

27 стр.

    Публикации 2

    показать свернуть
    25 июля 2018
    новость

    SPBTLE-1S - BLE модуль для интернета вещей от ST Microelectronics

    Компания ST Microelectronics выпустила радиомодуль SPBTLE–1S для быстрого создания законченных устройств интернета вещей с батарейным питанием. Модуль построен на базе малопотребляющей системы–на–кристалле BlueNRG–1 с... ...читать

    Внимание! Точность указанного на сайте описания товара не может быть гарантирована. Для получения более полной и точной информации о товаре смотрите техническое описание (Datasheet) на сайте производителя.