TEL 12-2423

Baar, 11. December 2014 Cleaning Guideline Scope This guideline covers hermetically sealed board mounted Traco converters. We do not recommend washing insert moulded products, where it is difficult to get them dry inside. Please check also, if there is an additional comment about washing in the datasheet or application note of the concerned product. Note: We do generally not recommend washing...
развернуть ▼ свернуть ▲
 

Технические характеристики

показать свернуть
Монтаж
Выходная мощность
Количество каналов
Входное напряжение
Параметры выходов
Возможности
Комплекс защит
Номинальное входное напряжение
Напряжение 1 выхода
Напряжение 2 выхода
Ток 1 выхода
Ток 2 выхода
КПД
Схема параллельного включения
Напряжение изоляции вход-выход
Сертификаты медицинские
Размер 23.8×17.3×8 мм
Рабочая температура
Нашли ошибку? Выделите её курсором и нажмите CTRL + ENTER

Аналоги 26

показать свернуть
Тип Наименование Корпус Упаковка i Монтаж P вых Каналов U вх Выход Возможности Защита U вх ном. U1 U2 U3 I1 I2 I3 Шум КПД Паралл. сх. Uиз. вх-вых Uиз. вх-общ Uиз. вых-общ Uиз. вых-вых Серт. медиц. T раб Примечания Карточка
товара
A- DKA15B-15 (MW) 2X1INCH в линейках 10 шт DC-DC модульный преобразователь - Монтаж: на плату, 2x1 inch; P вых: 15 Вт; #: 2; U вх:... короткого замыкания, перегрузки
A- DCW12C-15 (MW) DIP2410
 
короткого замыкания, перегрузки
A- DKE15B-15 (MW) 2X2INCH в линейках 5 шт DC-DC модульный преобразователь - Монтаж: на плату, 2x2 inch; P вых: 15 Вт; #: 2; U вх:... короткого замыкания, перегрузки
A- URA2415LD-20WR3 (MORNSUN) 2X1INCH 1 шт
A- URA2415ZP-10WR3 (MORNSUN) 1 шт
 
A- VRA2415LD-20WR3 (MORNSUN) 2X1INCH в линейках 10 шт
 
A- VRA2415ZP-10WR3 (MORNSUN) в линейках 200 шт
 
A- TEN 15-2423WI (TRACO) 2X1INCH в линейках 10 шт DC-DC модульный преобразователь - Монтаж: на плату, 2x1 inch; P вых: 15 Вт; #: 2; U вх:... Защита от КЗ: продолжительная с автовосстановлением
A- TEN 20-2423WIN (TRACO) 2X1INCH в линейках 10 шт DC-DC модульный преобразователь - Монтаж: на плату, 2x1 inch; P вых: 20 Вт; #: 2; U вх:... Защита от КЗ: продолжительная с автовосстановлением
A- THD 15-2423WIN (TRACO) DIP-24 в линейках 10 шт DC-DC модульный преобразователь - Монтаж: на плату, DIP24; P вых: 15 Вт; #: 2; U вх: 9....
A- DCW12A-15 (MW) DIP2410
 
короткого замыкания, перегрузки
A- DCW12B-15 (MW) DIP2410
 
короткого замыкания, перегрузки
A- TEL 12-4823WI (TRACO)
 
A- DKM10B-15 (MW) 2 шт короткого замыкания, перегрузки, перенапряжения, пониженного входного напряжения
A- DKA15A-15 (MW) 2X1INCH в линейках 10 шт DC-DC модульный преобразователь - Монтаж: на плату, 2x1 inch; P вых: 15 Вт; #: 2; U вх:... короткого замыкания, перегрузки
A- NSD10-12D15 (MW) 2X1INCH 1 шт DC-DC модульный преобразователь - Монтаж: на плату, 2x1 inch; P вых: 10 Вт; #: 2; U вх:... перегрузки, перенапряжения, перегрева
A- DKA15C-15 (MW) 2X1INCH в линейках 10 шт DC-DC модульный преобразователь - Монтаж: на плату, 2x1 inch; P вых: 15 Вт; #: 2; U вх:... короткого замыкания, перегрузки
A- NSD10-48D15 (MW) 2X1INCH 1 шт DC-DC модульный преобразователь - Монтаж: на плату, 2x1 inch; P вых: 10 Вт; #: 2; U вх:... перегрузки, перенапряжения, перегрева
A- NSD15-12D15 (MW) 2X15INCH на поддоне 30 шт DC-DC модульный преобразователь - Монтаж: на плату, 2x1.5 inch; P вых: 15 Вт; #: 2; U в... перегрузки, перенапряжения, перегрева
A- DKE10B-15 (MW) 2X1INCH в линейках 10 шт DC-DC модульный преобразователь - Монтаж: на плату, 2x1 inch; P вых: 10 Вт; #: 2; U вх:... короткого замыкания, перегрузки
A- NSD15-48D15 (MW) 2X15INCH 1 шт DC-DC модульный преобразователь - Монтаж: на плату, 2x1.5 inch; P вых: 15 Вт; #: 2; U в... подстройка выхода, компенсация на проводах перегрузки, перенапряжения, перегрева
A- DKE10C-15 (MW) 2X1INCH в линейках 10 шт DC-DC модульный преобразователь - Монтаж: на плату, 2x1 inch; P вых: 10 Вт; #: 2; U вх:... короткого замыкания, перегрузки
A- DKE15A-15 (MW) 2X2INCH в линейках 5 шт DC-DC модульный преобразователь - Монтаж: на плату, 2x2 inch; P вых: 15 Вт; #: 2; U вх:... короткого замыкания, перегрузки
A- DKE15C-15 (MW) 2X2INCH DC-DC модульный преобразователь - Монтаж: на плату, 2x2 inch; P вых: 15 Вт; #: 2; U вх:... короткого замыкания, перегрузки
A- DKM10A-15 (MW) короткого замыкания, перегрузки, перенапряжения, пониженного входного напряжения
A- DKM10C-15 (MW) короткого замыкания, перегрузки, перенапряжения, пониженного входного напряжения

Файлы 2

показать свернуть
Baar, 11. December 2014 Cleaning Guideline Scope This guideline covers hermetically sealed board mounted Traco converters. We do not recommend washing insert moulded products, where it is difficult to get them dry inside. Please check also, if there is an additional comment about washing in the datasheet or application note of the concerned product. Note: We do generally not recommend washing or cleaning electronic components. You should avoid it, if it is not absolutely necessary. It may reduce the reliability of the involved components in your application. Board cooling prior to cleaning process Converters and their associated application PCB assemblies should not be wash-cleaned after soldering until they had the opportunity to cool within the cleaning solution temperature. This will prevent vacuum absorption of the cleaning liquid into the module between the pins and the potting during cooling. Cleaning agents Cleaning method Classification Cleaning agents Water type Deionized water Ultrasonic wave Solvent type IPA Note: In general, the liquid temperature shall be less than 60°C. Cleaning process In aqueous cleaning, it is preferred to have an in-line cleaner system consisting of several cleaning stages (prewash, wash, rinse, final rinse, and drying). Deionised (DI) water is recommended for aqueous cleaning; the minimum resistively level is 1MΩ-cm. Tap-water quality varies per region in terms of hardness, chloride, and solid contents. Therefore, the use of tap water is not recommended for aqueous cleaning. Note: The total time of ultrasonic wave shall be less than 3 minutes. Drying After cleaning, assure that everything will be dry enough, that the moisture and other potential contaminants will not be present anymore. Use an air circulating chamber (e.g. 0.5-0.7m3/s) and thermal oven at 80-100°C (during 20-120min, depending on assembling, structure, components). Handheld air guns are not recommended. It is on customer’s own responsibility to ensure all components are dry. Product post-wash external appearance The marking or date-code may fade or disappear after cleaning. That does not concern the performance of the converter. Andreas Flühler, Head of Technical Services PDF
Рекомендации по промывке и сушке 

Cleaning Guideline

Дата модификации: 02.02.2021

Размер: 79 Кб

1 стр.

DC/DC Converter TEL 12 Series, 12 Watt • Ultra compact 12 Watt converter in DIP-16 metal casing • • Highest power density of 3,61W/cm3 • • Wide 2:1 input voltage range 6-side shielded metal case with insulated baseplate High efficiency (up to 88%) for low thermal loss • Operating temperature range -40°C to +88°C • • • Built-In EN 55032 class A filter Protection against short circuit 3-year product warranty UL 62368-1 IEC 62368-1 The TEL 12 is a 12 Watt DC/DC converter series which comes in an ultra compact DIP-16 metal package. The design purpose was to miniaturized low power DC/DC converters to the maximum without sacrificing high efficiency. They solidify the new standard for power density with 3,61 W/cm3 and effectively double the power density compared to 12 Watt converters in DIP-24 package. The TEL 12 and offers a wide 2:1 input voltage range and features a high efficiency of up to 88% which enables an operation temperature of up to +65°C at full load and up to 85°C with 50% load. The converters also have an internal input filter to comply with conducted emission standard EN 55032 class A. Overall they feature an economical solution for space critical and cost sensitive applications in instrumentation, IT and industrial electronics. Models Order Code Input Voltage Range TEL 12-1211 TEL 12-1212 TEL 12-1213 TEL 12-1215 TEL 12-1222 TEL 12-1223 TEL 12-2411 TEL 12-2412 TEL 12-2413 TEL 12-2415 TEL 12-2422 TEL 12-2423 TEL 12-4811 TEL 12-4812 TEL 12-4813 TEL 12-4815 TEL 12-4822 TEL 12-4823 www.tracopower.com 9 - 18 VDC (12 VDC nom.) 18 - 36 VDC (24 VDC nom.) 36 - 75 VDC (48 VDC nom.) Output 1 Output 2 Vnom Imax 5.1 VDC 12 VDC 15 VDC 24 VDC +12 VDC +15 VDC 5.1 VDC 12 VDC 15 VDC 24 VDC +12 VDC +15 VDC 5.1 VDC 12 VDC 15 VDC 24 VDC +12 VDC +15 VDC 2'400 mA 1'000 mA 800 mA 500 mA 500 mA 400 mA 2'400 mA 1'000 mA 800 mA 500 mA 500 mA 400 mA 2'400 mA 1'000 mA 800 mA 500 mA 500 mA 400 mA January 27, 2021 Vnom Efficiency Imax –12 VDC –15 VDC 500 mA 400 mA –12 VDC –15 VDC 500 mA 400 mA –12 VDC –15 VDC 500 mA 400 mA typ. 83 % 87 % 88 % 88 % 87 % 87 % 83 % 87 % 88 % 88 % 87 % 87 % 83 % 87 % 88 % 88 % 87 % 87 % Page 1 / 4 PDF
Документация на TEL12-4823 

TEL 12 Datasheet 12 Watt DC/DC converter, industrial, 2:1 input, ultra compact design, encapsulated, DIP-16 metal package

Дата модификации: 27.01.2021

Размер: 936 Кб

4 стр.

    Внимание! Точность указанного на сайте описания товара не может быть гарантирована. Для получения более полной и точной информации о товаре смотрите техническое описание (Datasheet) на сайте производителя.