TEL 8-1211

Baar, 11. December 2014 Cleaning Guideline Scope This guideline covers hermetically sealed board mounted Traco converters. We do not recommend washing insert moulded products, where it is difficult to get them dry inside. Please check also, if there is an additional comment about washing in the datasheet or application note of the concerned product. Note: We do generally not recommend washing...
развернуть ▼ свернуть ▲
 

Технические характеристики

показать свернуть
Монтаж
Выходная мощность
Количество каналов
Входное напряжение
Параметры выходов
Возможности DC-DC Regulated Power Supply Module, 1 Output, 8W, Hybrid
Комплекс защит
Номинальное входное напряжение
Напряжение 1 выхода
Ток 1 выхода
Схема параллельного включения
Напряжение изоляции вход-выход
Сертификаты медицинские
Размер 24.1×14×9 мм
Рабочая температура
Нашли ошибку? Выделите её курсором и нажмите CTRL + ENTER

Аналоги 24

показать свернуть
Тип Наименование Корпус Упаковка i Монтаж P вых Каналов U вх Выход Возможности Защита U вх ном. U1 U2 U3 I1 I2 I3 Шум КПД Паралл. сх. Uиз. вх-вых Uиз. вх-общ Uиз. вых-общ Uиз. вых-вых Серт. медиц. T раб Примечания Карточка
товара
A- PDQE10-Q24-S5-D (CUIDEV)
 
DC-DC Regulated Power Supply Module, 1 Output, 10W, Hybrid
A- JWE0848S05 (XP POWER)
 
DC-DC Regulated Power Supply Module, 1 Output, 8W, Hybrid
A- TSR 2-2450 (TRACO) SIP3 в линейках 10 шт короткого замыкания, перегрева DC/DC преобразователь без гальванической изоляции с высоким КПД
A- PT4243A (TI) SIP MODULE10
 
DC-DC Regulated Power Supply Module, 1 Output, 10W, Hybrid 10 WATT LOW PROFILE 24V-INPUT ISOLATED DC-DC CONVERTER
A- VRA0505YMD-10WR3 (MORNSUN)
 
DC-DC Regulated Power Supply Module, 2 Output, 10W, Hybrid SHORT CIRCUIT; OUTPUT OVER CURRENT; OUTPUT VOLTAGE
A- VRB0505YMD-10WR3 (MORNSUN)
 
DC-DC Regulated Power Supply Module, 1 Output, 10W, Hybrid SHORT CIRCUIT; OUTPUT OVER CURRENT; OUTPUT VOLTAGE
A- AMSR2-7805L-NZ (AIMTEC) 1 шт
 
DC-DC Regulated Power Supply Module, 1 Output, 10W, Hybrid
A- AMSRO1-7805-NZ (AIMTEC) 1 шт
 
DC-DC Regulated Power Supply Module, 2 Output, 6.5W, Hybrid
A- AM12TW-2405SZ (AIMTEC) 1 шт
 
A- MGS101205 (COSEL)
 
DC-DC Regulated Power Supply Module, 1 Output, 10W, Hybrid
A- V7805-2000 (CUIDEV)
 
DC-DC Regulated Power Supply Module, 1 Output, 10W, Hybrid
A- TPSM84205EAB (TI) SIP3 на поддоне 80 шт EMI Tested, Light Load Efficiency, Spread Spectrum Понижающий модульный DC/DC преобразователь
A- DFC10U24D5 (BELFUSE)
DFC10U24D5 (BELPOWER)
 
DC-DC Regulated Power Supply Module, 2 Output, 9W, Hybrid
A- ITZ0924S05 (XP POWER)
 
DC-DC Regulated Power Supply Module, 1 Output, 8W, Hybrid SHORT CIRCUIT; OUTPUT OVER VOLTAGE; OVER LOAD
A- EC4BW06 (CINCON)
 
DC-DC Regulated Power Supply Module, 2 Output, 10W, Hybrid
A- UWR-5/2000-D12A-C (MURATAPS)
 
DC-DC Regulated Power Supply Module, 1 Output, 10W, Hybrid
A- PYB10-Q24-D5 (CUIDEV)
 
DC-DC Regulated Power Supply Module, 2 Output, 10W, Hybrid
A- EC4BW11 (CINCON)
 
DC-DC Regulated Power Supply Module, 1 Output, 10W, Hybrid
A- PYB10-Q24-D5-T (CUIDEV)
 
DC-DC Regulated Power Supply Module, 2 Output, 10W, Hybrid SHORT CIRCUIT; OUTPUT OVER VOLTAGE
A- PYB10-Q24-D5-U (CUIDEV)
 
DC-DC Regulated Power Supply Module, 2 Output, 10W, Hybrid
A- SUTS100505 (COSEL)
 
DC-DC Regulated Power Supply Module, 1 Output, 10W, Hybrid
A- PYB10-Q24-S5-T (CUIDEV)
 
DC-DC Regulated Power Supply Module, 1 Output, 10W, Hybrid
A- PYB10-Q24-S5-U (CUIDEV)
 
DC-DC Regulated Power Supply Module, 1 Output, 10W, Hybrid
A- EC5A-12S05 (CINCON)
 
DC-DC Regulated Power Supply Module, 1 Output, 10W, Hybrid

Файлы 2

показать свернуть
Baar, 11. December 2014 Cleaning Guideline Scope This guideline covers hermetically sealed board mounted Traco converters. We do not recommend washing insert moulded products, where it is difficult to get them dry inside. Please check also, if there is an additional comment about washing in the datasheet or application note of the concerned product. Note: We do generally not recommend washing or cleaning electronic components. You should avoid it, if it is not absolutely necessary. It may reduce the reliability of the involved components in your application. Board cooling prior to cleaning process Converters and their associated application PCB assemblies should not be wash-cleaned after soldering until they had the opportunity to cool within the cleaning solution temperature. This will prevent vacuum absorption of the cleaning liquid into the module between the pins and the potting during cooling. Cleaning agents Cleaning method Classification Cleaning agents Water type Deionized water Ultrasonic wave Solvent type IPA Note: In general, the liquid temperature shall be less than 60°C. Cleaning process In aqueous cleaning, it is preferred to have an in-line cleaner system consisting of several cleaning stages (prewash, wash, rinse, final rinse, and drying). Deionised (DI) water is recommended for aqueous cleaning; the minimum resistively level is 1MΩ-cm. Tap-water quality varies per region in terms of hardness, chloride, and solid contents. Therefore, the use of tap water is not recommended for aqueous cleaning. Note: The total time of ultrasonic wave shall be less than 3 minutes. Drying After cleaning, assure that everything will be dry enough, that the moisture and other potential contaminants will not be present anymore. Use an air circulating chamber (e.g. 0.5-0.7m3/s) and thermal oven at 80-100°C (during 20-120min, depending on assembling, structure, components). Handheld air guns are not recommended. It is on customer’s own responsibility to ensure all components are dry. Product post-wash external appearance The marking or date-code may fade or disappear after cleaning. That does not concern the performance of the converter. Andreas Flühler, Head of Technical Services PDF
Рекомендации по промывке и сушке 

Cleaning Guideline

Дата модификации: 02.02.2021

Размер: 79 Кб

1 стр.

DC/DC Converter TEL 8 Series, 8 Watt • Ultra compact 8 W converter in DIP-16 metal casing • Operating temperature range -40°C to +80°C • • • • Wide 2:1 input range Built-in EN 55032 class A filter UL 62368-1 IEC 62368-1 Protection against short circuit 3-year product warranty The TEL 8 series is a range of isolated 8 Watt converters which come in a very compact DIP-16 metal package. They offer a 2:1 input voltage range and feature a high efficiency of up to 86% which allows an operation temperature of up to +70°C at full load. An input filter makes the converters comply with conducted emission EN 55032 class A. The TEL 8 Series models are an economical solution for space critical and cost sensitive applications in instrumentation, IT and industrial electronics. Models Order Code Input Voltage Range TEL 8-1210 TEL 8-1211 TEL 8-1212 TEL 8-1213 TEL 8-1215 TEL 8-1222 TEL 8-1223 TEL 8-2410 TEL 8-2411 TEL 8-2412 TEL 8-2413 TEL 8-2415 TEL 8-2422 TEL 8-2423 TEL 8-4810 TEL 8-4811 TEL 8-4812 TEL 8-4813 TEL 8-4815 TEL 8-4822 TEL 8-4823 www.tracopower.com 9 - 18 VDC (12 VDC nom.) 18 - 36 VDC (24 VDC nom.) 36 - 75 VDC (48 VDC nom.) Output 1 Output 2 Vnom Imax 3.3 VDC 5 VDC 12 VDC 15 VDC 24 VDC +12 VDC +15 VDC 3.3 VDC 5 VDC 12 VDC 15 VDC 24 VDC +12 VDC +15 VDC 3.3 VDC 5 VDC 12 VDC 15 VDC 24 VDC +12 VDC +15 VDC 1'600 mA 1'600 mA 665 mA 535 mA 335 mA 335 mA 265 mA 1'600 mA 1'600 mA 665 mA 535 mA 335 mA 335 mA 265 mA 1'600 mA 1'600 mA 665 mA 535 mA 335 mA 335 mA 265 mA January 18, 2021 Vnom Efficiency Imax –12 VDC –15 VDC 335 mA 265 mA –12 VDC –15 VDC 335 mA 265 mA –12 VDC –15 VDC 335 mA 265 mA typ. 78 % 81 % 84 % 84 % 85 % 85 % 84 % 78 % 82 % 85 % 85 % 86 % 85 % 86 % 78 % 81 % 85 % 85 % 86 % 86 % 86 % Page 1 / 4 PDF
Документация на TEL8-4823 

TEL 8 Datasheet 8 Watt DC/DC converter, industrial, 2:1 input, high power density, 6-side shielded, encapsulated, DIP-16

Дата модификации: 18.01.2021

Размер: 1.76 Мб

4 стр.

    Внимание! Точность указанного на сайте описания товара не может быть гарантирована. Для получения более полной и точной информации о товаре смотрите техническое описание (Datasheet) на сайте производителя.