TEN 40-2410WIN

TRACO
Baar, 11. December 2014 Cleaning Guideline Scope This guideline covers hermetically sealed board mounted Traco converters. We do not recommend washing insert moulded products, where it is difficult to get them dry inside. Please check also, if there is an additional comment about washing in the datasheet or application note of the concerned product. Note: We do generally not recommend washing...
развернуть ▼ свернуть ▲

Технические характеристики

показать свернуть
Монтаж
Выходная мощность
Количество каналов
Входное напряжение
Параметры выходов
Возможности
Комплекс защит короткого замыкания, перенапряжения, перегрева
Номинальное входное напряжение
Напряжение 1 выхода
Ток 1 выхода
Уровень пульсаций
КПД
Напряжение изоляции вход-выход
Размер 51×25.4×11 мм
Рабочая температура
Нашли ошибку? Выделите её курсором и нажмите CTRL + ENTER

Аналоги 26

показать свернуть
Тип Наименование Корпус Упаковка i Монтаж P вых Каналов U вх Выход Возможности Защита U вх ном. U1 U2 U3 I1 I2 I3 Шум КПД Паралл. сх. Uиз. вх-вых Uиз. вх-общ Uиз. вых-общ Uиз. вых-вых Серт. медиц. T раб Примечания Карточка
товара
P= RSDW40F-03 (MW)
 
1 шт КЗ, перегрузка, перенапряжение, от пониженного входного напряжения
A- VRB4803LD-50WR3A2S (MORNSUN)
 
 
от пониженного входного напряжения, обратного входного напряжения, короткого замыкания, перегрузки, перенапряжения
A- TEN 40-2410WIE (TRACO)
 
A- TEN 40-2433 (TRACO)
 
2X2INCH 1 шт DC-DC модульный преобразователь - Монтаж: на плату, 2x2 inch; P вых: 40 Вт; #: 3; U вх:... короткого замыкания, перенапряжения, перегрева Защита от КЗ: продолжительная с автовосстановлением. Указаны шумы на первом выходе
A- RP40-243.3SGW (RECOM)
 
2X2INCH в линейках 4 шт DC-DC модульный преобразователь - Монтаж: на плату, 2x2 inch; P вых: 40 Вт; #: 1; U вх:...
A- RSDW40G-03 (MW)
 
КЗ, перегрузка, перенапряжение, от пониженного входного напряжения
A- RSDW60F-03 (MW)
 
КЗ, перегрузка, перенапряжение, от пониженного входного напряжения
A- RSDW60G-03 (MW)
 
КЗ, перегрузка, перенапряжение, от пониженного входного напряжения
A- VRB4803LD-50WHR3 (MORNSUN)
 
 
от пониженного входного напряжения, короткого замыкания, перегрузки, перенапряжения
A- VRB4803LD-50WHR3A2S (MORNSUN)
 
 
от пониженного входного напряжения, обратного входного напряжения, короткого замыкания, перегрузки, перенапряжения
A- VRB4803LD-50WHR3A4S (MORNSUN)
 
 
от пониженного входного напряжения, обратного входного напряжения, короткого замыкания, перегрузки, перенапряжения
A- VRB4803LD-50WR3 (MORNSUN)
 
22 шт
 
от пониженного входного напряжения, короткого замыкания, перегрузки, перенапряжения
A- URB4803YMD-40WR3 (MORNSUN)
 
 
от пониженного входного напряжения, короткого замыкания, перегрузки, перенапряжения, перегрева
A- VRB4803LD-50WR3A4S (MORNSUN)
 
 
от пониженного входного напряжения, обратного входного напряжения, короткого замыкания, перегрузки, перенапряжения
A- VRB2403LD-50W-DT (MORNSUN)
 
 
A- VRB2403LD-50WHR3 (MORNSUN)
 
 
от пониженного входного напряжения, короткого замыкания, перегрузки, перенапряжения
A- VRB2403LD-50WHR3A2S (MORNSUN)
 
 
от пониженного входного напряжения, обратного входного напряжения, короткого замыкания, перегрузки, перенапряжения
A- VRB2403LD-50WHR3A4S (MORNSUN)
 
 
от пониженного входного напряжения, обратного входного напряжения, короткого замыкания, перегрузки, перенапряжения
A- VRB2403LD-50WR3 (MORNSUN)
 
 
от пониженного входного напряжения, короткого замыкания, перегрузки, перенапряжения
A- VRB2403LD-50WR3A2S (MORNSUN)
 
 
от пониженного входного напряжения, обратного входного напряжения, короткого замыкания, перегрузки, перенапряжения
A- VRB2403LD-50WR3A4S (MORNSUN)
 
3 шт
 
от пониженного входного напряжения, обратного входного напряжения, короткого замыкания, перегрузки, перенапряжения
A- TEN 40-4810 (TRACO)
 
2X2INCH в линейках 5 шт DC-DC модульный преобразователь - Монтаж: на плату, 2x2 inch; P вых: 40 Вт; #: 1; U вх:... короткого замыкания, перенапряжения, перегрева Защита от КЗ: продолжительная с автовосстановлением
A- TEN 40-4810E (TRACO)
 
A- TEN 40-4810WI (TRACO)
 
2X2INCH в линейках 5 шт DC-DC модульный преобразователь - Монтаж: на плату, 2x2 inch; P вых: 40 Вт; #: 1; U вх:... Защита от КЗ: продолжительная с автовосстановлением
A- TEN 40-4810WIE (TRACO)
 
A- TEN 50-1210 (TRACO)
 
2X1INCH 2 шт

Файлы 2

показать свернуть
Baar, 11. December 2014 Cleaning Guideline Scope This guideline covers hermetically sealed board mounted Traco converters. We do not recommend washing insert moulded products, where it is difficult to get them dry inside. Please check also, if there is an additional comment about washing in the datasheet or application note of the concerned product. Note: We do generally not recommend washing or cleaning electronic components. You should avoid it, if it is not absolutely necessary. It may reduce the reliability of the involved components in your application. Board cooling prior to cleaning process Converters and their associated application PCB assemblies should not be wash-cleaned after soldering until they had the opportunity to cool within the cleaning solution temperature. This will prevent vacuum absorption of the cleaning liquid into the module between the pins and the potting during cooling. Cleaning agents Cleaning method Classification Cleaning agents Water type Deionized water Ultrasonic wave Solvent type IPA Note: In general, the liquid temperature shall be less than 60°C. Cleaning process In aqueous cleaning, it is preferred to have an in-line cleaner system consisting of several cleaning stages (prewash, wash, rinse, final rinse, and drying). Deionised (DI) water is recommended for aqueous cleaning; the minimum resistively level is 1MΩ-cm. Tap-water quality varies per region in terms of hardness, chloride, and solid contents. Therefore, the use of tap water is not recommended for aqueous cleaning. Note: The total time of ultrasonic wave shall be less than 3 minutes. Drying After cleaning, assure that everything will be dry enough, that the moisture and other potential contaminants will not be present anymore. Use an air circulating chamber (e.g. 0.5-0.7m3/s) and thermal oven at 80-100°C (during 20-120min, depending on assembling, structure, components). Handheld air guns are not recommended. It is on customer’s own responsibility to ensure all components are dry. Product post-wash external appearance The marking or date-code may fade or disappear after cleaning. That does not concern the performance of the converter. Andreas Flühler, Head of Technical Services PDF
Рекомендации по промывке и сушке 

Cleaning Guideline

Дата модификации: 02.02.2021

Размер: 79 Кб

1 стр.

DC/DC Converters TEN 40WIN Series, 40 Watt C Bending Features ◆ Highest power density: Scheme p 40 W in 1” x 2” x 0.4” package ◆ ◆ ◆ ◆ ◆ Ultra wide 4:1 input range Excellent efficiency up to 90 % Output voltage adjustable Remote On/Off Protection against short circuit and over voltage ◆ I/O isolation 1500 VDC ◆ Operating temperature range –40°C to +75°C The TEN 40WIN Series is a new range of isolated high ��������������������������� performance DC/DC-con� verter modules. Due to the very high efficiency of up to 90% these 40 W converters come with a footprint of only 1.0” x 2.0”. The 12 models have an ultra wide 4:1 input voltage range and a tight output voltage regulation. The output voltage is ad� justable by external resistor. Remote On/Off and protection against overpower and over voltage are standard features of these converters. Typical applications are in mobile equipment, instrumentation, distributed power architectures in communication and industrial electronics and everywhere where space on the PCB is limited. ◆ 3-year product warranty Models Order code Output voltage Output current max. Efficiency TEN 40-2410WIN 3.3 VDC 8‘000 mA 89 % TEN 40-2411WIN 5.0 VDC 8’000 mA 90 % 12 VDC 3‘330 mA 89 % 15 VDC 2‘670 mA 89 % 24 VDC 1‘670 mA 89 % TEN 40-2422WIN ±12 VDC ±1’670 mA 88 % TEN 40-2423WIN ±15 VDC ±1‘330 mA 88 % TEN 40-4810WIN 3.3 VDC 8‘000 mA 89 % TEN 40-4811WIN 5.0 VDC 8’000 mA 90 % 12 VDC 3‘330 mA 90 % 15 VDC 2‘670 mA 90 % 24 VDC 1‘670 mA 89 % TEN 40-4822WIN ±12 VDC 1’666 mA 88 % TEN 40-4823WIN ±15 VDC 1‘330 mA 88 % TEN 40-2412WIN TEN 40-2413WIN TEN 40-2415WIN TEN 40-4812WIN TEN 40-4813WIN TEN 40-4815WIN http://www.tracopower.com Input voltage range 9 – 36 VDC (nominal 24 VDC) 18 – 75 VDC (nominal 48 VDC) Page 1 of 4 PDF
Документация на серию TEN40WIN 

Дата модификации: 12.10.2012

Размер: 366.5 Кб

4 стр.

    Внимание! Точность указанного на сайте описания товара не может быть гарантирована. Для получения более полной и точной информации о товаре смотрите техническое описание (Datasheet) на сайте производителя.