TEN 60-1215N

TRACO
Baar, 11. December 2014 Cleaning Guideline Scope This guideline covers hermetically sealed board mounted Traco converters. We do not recommend washing insert moulded products, where it is difficult to get them dry inside. Please check also, if there is an additional comment about washing in the datasheet or application note of the concerned product. Note: We do generally not recommend washing...
развернуть ▼ свернуть ▲

Технические характеристики

показать свернуть
Монтаж
Выходная мощность
Количество каналов
Входное напряжение
Параметры выходов
Возможности
Комплекс защит от пониженного входного напряжения
Номинальное входное напряжение
Напряжение 1 выхода
Ток 1 выхода
Уровень пульсаций
КПД
Напряжение изоляции вход-выход
Размер 50.8×25.4×10.2 мм
Рабочая температура
Нашли ошибку? Выделите её курсором и нажмите CTRL + ENTER

Аналоги 31

показать свернуть
Тип Наименование Корпус Упаковка i Монтаж P вых Каналов U вх Выход Возможности Защита U вх ном. U1 U2 U3 I1 I2 I3 Шум КПД Паралл. сх. Uиз. вх-вых Uиз. вх-общ Uиз. вых-общ Uиз. вых-вых Серт. медиц. T раб Примечания Карточка
товара
A- TEN 50-2415WI (TRACO)
 
2X1INCH в линейках 10 шт
A- SD-50B-24 (MW)
 
1 шт DC-DC модульный преобразователь - Монтаж: в кожухе; P вых: 50 Вт; #: 1; U вх: 19...36 В... короткого замыкания, перегрузки, перенапряжения
A- SD-100B-24 (MW)
 
1 шт короткого замыкания, перегрузки, перенапряжения
A- RSD-60G-24 (MW)
 
1 шт КЗ, перегрузка, перенапряжение, обратной полярности
A- RSD-100B-24 (MW)
 
в коробках 24 шт DC-DC модульный преобразователь - Монтаж: в кожухе; P вых: 100.8 Вт; #: 1; U вх: 16.8..... короткого замыкания, перегрузки, перенапряжения, переполюсовки
A- MHB75-12S24 (MW)
 
1 шт DC-DC, 75Вт, вход 9…18В, выход 24В/3.13А, рег.выхода ±10% Uном, изоляция 1500В DC, в ко... короткого замыкания, перегрузки, перенапряжения
A- DDR-60L-24 (MW)
 
1 шт КЗ, переполюсовки, пониженного входного напряжения
A- DDR-60G-24 (MW)
 
в коробках 20 шт КЗ, переполюсовки, пониженного входного напряжения
A- SD-50A-24 (MW)
 
в коробках 24 шт короткого замыкания, перегрузки, перенапряжения
A- RPA60-2424SFW/P (RECOM)
 
в линейках 5 шт
 
A- TEN 60-2425WIR (TRACO)
 
A- TEN 60-2425WIN (TRACO)
 
2X1INCH 2 шт подстройка выхода, дистанционное управление
A- TEN 60-2415WIR (TRACO)
 
1 шт
A- TEN 50-1215 (TRACO)
 
2X1INCH 1 шт
A- RPA60-2424SFW/N (RECOM)
 
в линейках 5 шт
 
A- URF2424QB-100WR3 (MORNSUN)
 
2 шт КЗ, перегрев, перегрузка, перенапряжение, от пониженного входного напряжения
A- MHB100-24S24 (MW)
 
на поддоне 12 шт DC-DC модульный преобразователь - Монтаж: на плату; P вых: 100 Вт; #: 1; U вх: 18...36 ... короткого замыкания, перегрузки, перенапряжения
A- VRB2424LD-50W (MORNSUN)
 
2X1INCH
 
A- URF2424QB-100WR3A5 (MORNSUN)
 
КЗ, перегрев, перегрузка, перенапряжение, от пониженного входного напряжения
A- URF2424QB-100WHR3A5 (MORNSUN)
 
КЗ, перегрев, перегрузка, перенапряжение, от пониженного входного напряжения
A- URF2424QB-100WHR3 (MORNSUN)
 
на поддоне 80 шт КЗ, перегрев, перегрузка, перенапряжение, от пониженного входного напряжения
A- URF2424QB-100WFR3 (MORNSUN)
 
КЗ, перегрев, перегрузка, перенапряжение, от пониженного входного напряжения
A- MHB75-24S24 (MW)
 
на поддоне 3 шт DC-DC модульный преобразователь - Монтаж: на плату; P вых: 75 Вт; #: 1; U вх: 18...36 В... короткого замыкания, перегрузки, перенапряжения
A- URB2424LD-50WHR3 (MORNSUN)
 
в линейках 2 шт
 
от пониженного входного напряжения, короткого замыкания, перегрузки, перенапряжения
A- DDR-120A-24 (MW)
 
в коробках 28 шт КЗ, переполюсовки, пониженного входного напряжения
A- RSDW60G-24 (MW)
 
1 шт КЗ, перегрузка, перенапряжение, от пониженного входного напряжения
A- RSDW60F-24 (MW)
 
в линейках 2 шт КЗ, перегрузка, перенапряжение, от пониженного входного напряжения
A- RSD-60L-24 (MW)
 
1 шт КЗ, перегрузка, перенапряжение, обратной полярности
A- PH100F24-24 (LAMBDA)
 
1 шт DC-DC модульный преобразователь - Монтаж: в кожухе; P вых: 100 Вт; #: 1; U вх: 18...36 ... регулировка выхода, дистанционное управление, компенсация на проводах, Power Good, параллельное включение короткого замыкания, перегрузки, перенапряжения, перегрева
A- TEN 60-2415WIN (TRACO)
 
2X1INCH в линейках 10 шт подстройка выхода, дистанционное управление Защита от КЗ: продолжительная с автовосстановлением
A- VRB2424LD-50WHR3 (MORNSUN)
 
 
от пониженного входного напряжения, короткого замыкания, перегрузки, перенапряжения

Файлы 2

показать свернуть
Baar, 11. December 2014 Cleaning Guideline Scope This guideline covers hermetically sealed board mounted Traco converters. We do not recommend washing insert moulded products, where it is difficult to get them dry inside. Please check also, if there is an additional comment about washing in the datasheet or application note of the concerned product. Note: We do generally not recommend washing or cleaning electronic components. You should avoid it, if it is not absolutely necessary. It may reduce the reliability of the involved components in your application. Board cooling prior to cleaning process Converters and their associated application PCB assemblies should not be wash-cleaned after soldering until they had the opportunity to cool within the cleaning solution temperature. This will prevent vacuum absorption of the cleaning liquid into the module between the pins and the potting during cooling. Cleaning agents Cleaning method Classification Cleaning agents Water type Deionized water Ultrasonic wave Solvent type IPA Note: In general, the liquid temperature shall be less than 60°C. Cleaning process In aqueous cleaning, it is preferred to have an in-line cleaner system consisting of several cleaning stages (prewash, wash, rinse, final rinse, and drying). Deionised (DI) water is recommended for aqueous cleaning; the minimum resistively level is 1MΩ-cm. Tap-water quality varies per region in terms of hardness, chloride, and solid contents. Therefore, the use of tap water is not recommended for aqueous cleaning. Note: The total time of ultrasonic wave shall be less than 3 minutes. Drying After cleaning, assure that everything will be dry enough, that the moisture and other potential contaminants will not be present anymore. Use an air circulating chamber (e.g. 0.5-0.7m3/s) and thermal oven at 80-100°C (during 20-120min, depending on assembling, structure, components). Handheld air guns are not recommended. It is on customer’s own responsibility to ensure all components are dry. Product post-wash external appearance The marking or date-code may fade or disappear after cleaning. That does not concern the performance of the converter. Andreas Flühler, Head of Technical Services PDF
Рекомендации по промывке и сушке 

Cleaning Guideline

Дата модификации: 02.02.2021

Размер: 79 Кб

1 стр.

DC/DC Converters TEN 60N Series, 60 Watt CB Scheme Features ◆ 2” x 1” metal package ◆ Wide 2:1 input voltage range UL 60950-1 UL 60950-1 9–18, 18–36, 36–75 VDC ◆ ◆ ◆ ◆ High efficiency up to 92% ◆ ◆ ◆ ◆ ◆ Input filter to meet EN55022, class A Adjustable output voltage No minimum load required Operating temperature range –40°C to +85°C Remote On/Off Under voltage lockout Lead free design, RoHS compliant 3-year product warranty The TEN 60N series is a family of high performance 60 Watt dc/dc converter modules featuring wide 2:1 input voltage ranges in a six side shielded 2” x 1” metal package with industry standard footprint. Standard features include remote On/Off, over voltage protection, under voltage lockout and short circuit protection. High efficiency across load range and low input current characteristics at no load make these converters the ideal solution for battery-operated systems. Typical applications are in wireless networks, telecom/datacom, industry control systems and measurement equipment. Models Order code TEN 60-1211N TEN 60-1212N TEN 60-1213N TEN 60-1215N TEN 60-1222N TEN 60-1223N TEN 60-1225N TEN 60-2411N TEN 60-2412N TEN 60-2413N TEN 60-2415N TEN 60-2422N TEN 60-2423N TEN 60-2425N TEN 60-4811N TEN 60-4812N TEN 60-4813N TEN 60-4815N TEN 60-4822N TEN 60-4823N TEN 60-4825N http://www.tracopower.com Input voltage range 9 – 18 VDC (12 VDC nominal) 18 – 36 VDC (24 VDC nominal) 36 – 75 VDC (48 VDC nominal) Output voltage Output current max. Efficiency typ. 5.0 VDC 12 VDC 15 VDC 24 VDC ±12 VDC ±15 VDC ±24 VDC 5.0 VDC 12 VDC 15 VDC 24 VDC ±12 VDC ±15 VDC ±24 VDC 5.0 VDC 12 VDC 15 VDC 24 VDC ±12 VDC ±15 VDC ±24 VDC 12‘000 mA 5000 mA 4000 mA 2500 mA ±2500 mA ±2000 mA ±1250 mA 12‘000 mA 5000 mA 4000 mA 2500 mA ±2500 mA ±2000 mA ±1250 mA 12‘000 mA 5000 mA 4000 mA 2500 mA ±2500 mA ±2000 mA ±1250 mA 90.5 % 90.5 % 91.5 % 91.5 % 90 % 90 % 91 % 92 % 92 % 92 % 92 % 90 % 90 % 91 % 92 % 92 % 92 % 92 % 91 % 91 % 91 % Page 1 of 4 PDF
Документация на серию TEN60N 

datasheet

Дата модификации: 02.06.2016

Размер: 233.8 Кб

4 стр.

    Внимание! Точность указанного на сайте описания товара не может быть гарантирована. Для получения более полной и точной информации о товаре смотрите техническое описание (Datasheet) на сайте производителя.