TRV 1-0523M

TRACO
Baar, 11. December 2014 Cleaning Guideline Scope This guideline covers hermetically sealed board mounted Traco converters. We do not recommend washing insert moulded products, where it is difficult to get them dry inside. Please check also, if there is an additional comment about washing in the datasheet or application note of the concerned product. Note: We do generally not recommend washing...
развернуть ▼ свернуть ▲
Внешний вид серии TRV_1M

Технические характеристики

показать свернуть
Монтаж
Выходная мощность
Количество каналов
Входное напряжение
Параметры выходов
Возможности
Комплекс защит
Номинальное входное напряжение
Напряжение 1 выхода
Напряжение 2 выхода
Ток 1 выхода
Ток 2 выхода
КПД
Напряжение изоляции вход-выход
Рабочая температура
Нашли ошибку? Выделите её курсором и нажмите CTRL + ENTER

Аналоги 24

показать свернуть
Тип Наименование Корпус Упаковка i Монтаж P вых Каналов U вх Выход Возможности Защита U вх ном. U1 U2 U3 I1 I2 I3 Шум КПД Паралл. сх. Uиз. вх-вых Uиз. вх-общ Uиз. вых-общ Uиз. вых-вых Серт. медиц. T раб Примечания Карточка
товара
A- TMV 0515D EN (TRACO)
 
SIP76 — — — — — — — —
A- TBA 1-0523HI (TRACO)
 
— — — — — — — — — —
A- TSM 0515D (TRACO)
 
SMD1810 в линейках 10 шт DC-DC модульный преобразователь - Монтаж: на плату, SMD18; P вых: 1 Вт; #: 2; U вх: 4.5... — — — — — —
A- A0515S-1WR3 (MORNSUN)
 
SIP76 в линейках 300 шт — — — — — — —
A- P6CU-0515ZLF (PEAK)
 
SIP7 в линейках 20 шт
 
 — — — — — — — Суффикс LF означает отсутствие свинца
A- TRA 1-0523 (TRACO)
 
SIP7 в линейках 10 шт
 
 — — — — — — — —
A- TMR 1-0523 (TRACO)
 
SIP6
 
 — — — — — — — — —
A- TMR 1-0523SM (TRACO)
 
SMD148 — — — — — — — — Защита от КЗ: продолжительная с автовосстановлением
A- TES 1-0523 (TRACO)
 
SMD8 в линейках 10 шт DC-DC модульный преобразователь - Монтаж: на плату, SMD; P вых: 1 Вт; #: 2; U вх: 4.5..... — — — — — — — —
A- TES 1-0523V (TRACO)
 
SMD1210 в линейках 10 шт DC-DC модульный преобразователь - Монтаж: на плату, SMD; P вых: 1 Вт; #: 2; U вх: 4.5..... — — — — — — — —
A- TBA 1-0523E (TRACO)
 
— — — — — — — — — —
A- TMA 0515D (TRACO)
 
SIP6 в линейках 10 шт DC-DC модульный преобразователь - Монтаж: на плату, SIP7; P вых: 1 Вт; #: 2; U вх: 4.5.... — — — — — — — —
A- UWE1215S-1WR3 (MORNSUN)
 
— — — — — — — —
A- TMV 0515D (TRACO)
 
SIP7 в линейках 10 шт DC-DC модульный преобразователь - Монтаж: на плату, SIP7; P вых: 1 Вт; #: 2; U вх: 4.5.... короткого замыкания, перенапряжения, перегрева — — — — — — — —
A- TSV 0515D (TRACO)
 
SMD1210 в линейках 10 шт DC-DC модульный преобразователь - Монтаж: на плату, SMD12; P вых: 1 Вт; #: 2; U вх: 4.5... — — — — — — — —
A- A0515D-1WR2 (MORNSUN)
 
DIP148 — — — — — — —
A- A0515S-1WR2 (MORNSUN)
 
SIP76 — — — — — — —
A- A0515XT-1WR2 (MORNSUN)
 
SMD10 2 шт — — — — — — —
A- A0515XT-1WR3 (MORNSUN)
 
SMD10 в линейках 610 шт — — — — — — —
A- E0515LT-1WR3 (MORNSUN)
 
SMD10 — — — — — — —
A- E0515S-1WR3 (MORNSUN)
 
SIP76 в линейках 600 шт — — — — — — —
A- E0515XT-1WR3 (MORNSUN)
 
SMD10 — — — — — — —
A- WRA0515S-1WR2 (MORNSUN)
 
SIP87 — — — — — — —
A- IE0515KS-1WR3 (MORNSUN)
 
— — — — — — — —

Файлы 2

показать свернуть
Baar, 11. December 2014 Cleaning Guideline Scope This guideline covers hermetically sealed board mounted Traco converters. We do not recommend washing insert moulded products, where it is difficult to get them dry inside. Please check also, if there is an additional comment about washing in the datasheet or application note of the concerned product. Note: We do generally not recommend washing or cleaning electronic components. You should avoid it, if it is not absolutely necessary. It may reduce the reliability of the involved components in your application. Board cooling prior to cleaning process Converters and their associated application PCB assemblies should not be wash-cleaned after soldering until they had the opportunity to cool within the cleaning solution temperature. This will prevent vacuum absorption of the cleaning liquid into the module between the pins and the potting during cooling. Cleaning agents Cleaning method Classification Cleaning agents Water type Deionized water Ultrasonic wave Solvent type IPA Note: In general, the liquid temperature shall be less than 60°C. Cleaning process In aqueous cleaning, it is preferred to have an in-line cleaner system consisting of several cleaning stages (prewash, wash, rinse, final rinse, and drying). Deionised (DI) water is recommended for aqueous cleaning; the minimum resistively level is 1MΩ-cm. Tap-water quality varies per region in terms of hardness, chloride, and solid contents. Therefore, the use of tap water is not recommended for aqueous cleaning. Note: The total time of ultrasonic wave shall be less than 3 minutes. Drying After cleaning, assure that everything will be dry enough, that the moisture and other potential contaminants will not be present anymore. Use an air circulating chamber (e.g. 0.5-0.7m3/s) and thermal oven at 80-100°C (during 20-120min, depending on assembling, structure, components). Handheld air guns are not recommended. It is on customer’s own responsibility to ensure all components are dry. Product post-wash external appearance The marking or date-code may fade or disappear after cleaning. That does not concern the performance of the converter. Andreas Flühler, Head of Technical Services PDF
Рекомендации по промывке и сушке 

Cleaning Guideline

Дата модификации: 02.02.2021

Размер: 79 Кб

1 стр.

DC/DC Medical Converter • • • • I/O isolation 5000 VAC (reinforced) • Operating temperature range -40 to +85 °C without derating • Certification according to IEC/EN/ES 60601-1 3rd edition for 2xMOPP and IEC/EN/UL 62368-1 • • • • Low leakage current < 2 μA TRV 1M Series, 1 Watt Short circuit protection Semi-regulated outputs Input voltage ranges (±10%): 5, 12, 15, 24 VDC Efficiency up to 85% Operation up to 5000 m altitude 5-year product warranty ES 60601-1 IEC 60601-1 UL 62368-1 IEC 62368-1 The TRV 1M is a series of 1 Watt DC/DC converters in a compact SIP-9 package with reinforced isolation of 5000 VAC for medical and industrial applications. The series offers models with different input voltages (±10%) between 5 and 24 VDC. With a continuous short circuit protection and a low leakage current of less than 2 µA, this converter series is especially suited to protect any connected interfaces or applied parts to patients. Featuring semi-regulated outputs this series provides a good level of regulation without affecting the cost efficiency. It is an ideal solution for applications where a completely unregulated DC/DC converter would not meet you regulation requirements and therefore opens up the overall application range of this series. Together with an operating temperature range from -40 to +85C° without derating and certifications according to IEC/EN/ES 60601-1 3rd ed. for 2xMOPP and IEC/EN/UL 62368-1 this series is suitable for many different applications where a medical isolation system and short circuit protection is needed. Models Order Code Input Voltage Range TRV 1-0510M TRV 1-0511M TRV 1-0512M TRV 1-0513M TRV 1-0521M TRV 1-0522M TRV 1-0523M TRV 1-1210M TRV 1-1211M TRV 1-1212M TRV 1-1213M TRV 1-1221M TRV 1-1222M TRV 1-1223M TRV 1-1510M TRV 1-1511M TRV 1-1512M TRV 1-1513M TRV 1-1521M TRV 1-1522M TRV 1-1523M TRV 1-2410M TRV 1-2411M TRV 1-2412M TRV 1-2413M TRV 1-2421M TRV 1-2422M TRV 1-2423M Note 4.5 - 5.5 VDC (5 VDC nom.) 9.6 - 14.4 VDC (12 VDC nom.) 12 - 18 VDC (15 VDC nom.) 19.2 - 28.8 VDC (24 VDC nom.) Output 1 Output 2 Vnom Imax 3.3 VDC 5 VDC 12 VDC 15 VDC +5 VDC +12 VDC +15 VDC 3.3 VDC 5 VDC 12 VDC 15 VDC +5 VDC +12 VDC +15 VDC 3.3 VDC 5 VDC 12 VDC 15 VDC +5 VDC +12 VDC +15 VDC 3.3 VDC 5 VDC 12 VDC 15 VDC +5 VDC +12 VDC +15 VDC 303 mA 200 mA 83 mA 67 mA 100 mA 42 mA 34 mA 303 mA 200 mA 83 mA 67 mA 100 mA 42 mA 34 mA 303 mA 200 mA 83 mA 67 mA 100 mA 42 mA 34 mA 303 mA 200 mA 83 mA 67 mA 100 mA 42 mA 34 mA Vnom Efficiency Imax –5 VDC –12 VDC –15 VDC 100 mA 42 mA 34 mA –5 VDC –12 VDC –15 VDC 100 mA 42 mA 34 mA –5 VDC –12 VDC –15 VDC 100 mA 42 mA 34 mA –5 VDC –12 VDC –15 VDC 100 mA 42 mA 34 mA typ. 80 % 82 % 85 % 84 % 85 % 85 % 84 % 80 % 82 % 84 % 83 % 82 % 83 % 83 % 79 % 83 % 84 % 84 % 82 % 83 % 83 % 78 % 82 % 83 % 83 % 80 % 81 % 81 % - 5 Vin models: If the input will be switched electromechanically, use an external 100 μF/10 V E/C. to avoid voltage transient. www.tracopower.com October 27, 2020 Page 1 / 4 PDF
Документация на серию TRV_1M 

TRV 1M Datasheet 1 Watt DC/DC converter, medical/industrial, ±10% input, semi-regulated, 5000 VAC isolation, 2xMOPP, encpasulated, SIP-9

Дата модификации: 27.10.2020

Размер: 2.54 Мб

4 стр.

    Внимание! Точность указанного на сайте описания товара не может быть гарантирована. Для получения более полной и точной информации о товаре смотрите техническое описание (Datasheet) на сайте производителя.

    DCH010505SN7 (TI)