Серия AC-DC сетевых преобразователей APV-35

Общие характеристики

Раздел AC-DC сетевые преобразователи
Тип стабилизации
Конструктивное исполнение
Типы защиты КЗ, перегрузка, перенапряжение
Количество выходов
Тип управления выходом
Входное напряжение AC
Входное напряжение DC
Коэффициент мощности
Напряжение изоляции вход-выход
Размер 84×57×29 мм
Рабочая температура

Документация на серию APV-35

A P V- 3 5 35W Single Output Switching Power Supply series ■ Features : ‧Constant voltage mode power supply ‧Universal AC input / Full range ‧Withstand 300VAC Surge input for 5 seconds ‧Protections: Short circuit / Over load / Over voltage ‧Fully isolated plastic case ‧Cooling by free air convection ‧Small and compact size ‧IP30 design ‧Pass LPS ‧100% full load burn-in test ‧Low cost, high reliability ‧Suitable for LED lighting and moving sign applications ‧2 years warranty SPECIFICATION APV-35-5 APV-35-12 APV-35-15 APV-35-24 APV-35-36 DC VOLTAGE 5V 12V 15V 24V 36V RATED CURRENT 5A 3A 2.4A 1.5A 1A CURRENT RANGE 0 ~ 5A 0 ~ 3A 0 ~ 2.4A 0 ~ 1.5A 0 ~ 1A RATED POWER 25W 36W 36W 36W 36W 150mVp-p 150mVp-p 180mVp-p 180mVp-p 84% 85% MODEL OUTPUT RIPPLE & NOISE (max.) Note.2 120mVp-p VOLTAGE TOLERANCE Note.3 ±5.0% ±1.0% LINE REGULATION ±2.0% LOAD REGULATION SETUP, RISE TIME Note.6 1500ms, 40ms / 230VAC HOLD UP TIME (Typ.) VOLTAGE RANGE INPUT 20ms/230VAC Note.4 90 ~ 264VAC EFFICIENCY (Typ.) 76.5% AC CURRENT INRUSH CURRENT(Typ.) 0.5A/230VAC 0.75A/115VAC COLD START 45A(twidth=440μs measured at 50% Ipeak) at 230VAC OVER LOAD OVER VOLTAGE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT 84% 0.25mA / 240VAC 110%~160% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed 13.8 ~ 16.2V 27 ~ 32.4V 17.25 ~ 21V 5.75 ~ 6.95V -30 ~ 70℃(Refer to "Derating Curve") 20 ~ 90% RH non-condensing -40 ~ +80℃, 10 ~ 95% RH SAFETY STANDARDS UL8750 , CSA-C22.2 No. 250.0-13 approved; design refer to EN60950-1 WITHSTAND VOLTAGE I/P-O/P:3KVAC I/P-O/P:>100M Ohms / 500VDC / 25℃/ 70% RH ISOLATION RESISTANCE EMC EMISSION DIMENSION 41.4 ~ 48.6V Protection type : Shut down o/p voltage, re-power on to recover ±0.03%/℃ (0 ~ 50℃) 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes PACKING NOTE 83% VIBRATION EMC IMMUNITY MTBF OTHERS 127 ~ 370VDC 47 ~ 63Hz PROTECTION EMC 1500ms,40ms / 115VAC at full load 12ms/115VAC at full load FREQUENCY RANGE LEAKAGE CURRENT SAFETY & LPS Compliance to EN55022,EN61000-3-2 Class A,EN61000-3-3 Compliance to EN55024,EN61000-4-2,3,4,5,6,8,11; light industry level(surge 2KV), criteria A 692.8K hrs min. MIL-HDBK-217F (25℃) 84*57*29.5mm (L*W*H) 0.18Kg; 72pcs / 14Kg/ 0.92CUFT 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Derating may be needed under low input voltage. Please check the static characteristics for more details. 5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again. 6. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time. 7.The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit. File Name:APV-35-SPEC 2013-06-28 PDF
Документация на серию APV-35 


Дата модификации: 01.07.2013

Размер: 475.7 Кб

2 стр.

    Товары серии APV-35

    Наименование i Упаковка P вых Выход U1 I1
    APV-35-12 (MW) в коробках 72 шт
    APV-35-15 (MW) 1 шт
    APV-35-24 (MW) 1 шт
    APV-35-36 (MW) Ед.изм-шт. Schaltnetzteil 36V 1A 36W 5 шт
    APV-35-5 (MW) 1 шт