PSD-05-24

DC-DC открытый, 5Вт, Uвх=36-72VDC, один выход +24В/0,22А, изоляция 1,5кVAC (вх-вых), 1,5кVAC (вх-корп), 75х40х21 мм, -10...+60°С (со сниж. мощн.) Производитель: MEAN WELL
развернуть ▼ свернуть ▲

Технические характеристики

показать свернуть
Монтаж
Выходная мощность
Количество каналов
Входное напряжение
Параметры выходов
Возможности
Комплекс защит короткого замыкания, перегрузки, перенапряжения, перегрева
Номинальное входное напряжение
Напряжение 1 выхода
Ток 1 выхода
Уровень пульсаций
КПД
Схема параллельного включения
Напряжение изоляции вход-выход
Напряжение изоляции вход-земля
Сертификаты медицинские
Размер 75×40×20 мм
Рабочая температура
Нашли ошибку? Выделите её курсором и нажмите CTRL + ENTER

Аналоги 17

показать свернуть
Тип Наименование Корпус Упаковка i Монтаж P вых Каналов U вх Выход Возможности Защита U вх ном. U1 U2 U3 I1 I2 I3 Шум КПД Паралл. сх. Uиз. вх-вых Uиз. вх-общ Uиз. вых-общ Uиз. вых-вых Серт. медиц. T раб Примечания Карточка
товара
A- VRB2424YMD-6WR3 (MORNSUN)
 
A- CUWB1224YMD-6WR3 (MORNSUN)
 
SMD8
 
от пониженного входного напряжения, КЗ, перегрузки, перенапряжения
A- URB2424S-6WR3 (MORNSUN)
 
SIP87 10 шт
A- DKMW06F-24 (MW)
 
 
DC-DC Regulated Power Supply Module
A- SKMW06F-24 (MW)
 
1 шт
 
DC-DC Regulated Power Supply Module
A- SKMW06G-24 (MW)
 
1X1INCH в линейках 19 шт
 
DC-DC Regulated Power Supply Module
A- VRA2424ZP-6WR3 (MORNSUN)
 
DIP-8 в линейках 19 шт
A- URB2424YMD-6WR3 (MORNSUN)
 
A- URB2424ZP-6WR3 (MORNSUN)
 
DIP-24 в линейках 30 шт
A- URB4824ZP-6WR3 (MORNSUN)
 
DIP-8 DIP7 1 шт
A- VRB2424S-6WR3 (MORNSUN)
 
SIP87 в линейках 5 шт
A- VRB2424ZP-6WR3 (MORNSUN)
 
A- K78U24-300R3 (MORNSUN)
 
 
A- URF2424P-6WR3 (MORNSUN)
 
DIP2410 1 шт
A- URH2424P-6WR3 (MORNSUN)
 
DIP2410 в линейках 150 шт
A- URA2424YMD-6WR3 (MORNSUN)
 
1 шт
A- URA2424ZP-6WR3 (MORNSUN)
 
1 шт

Файлы 2

показать свернуть
P S D - 0 5 series 5W Single Output DC-DC Converter ■ Features : 2:1 wide input range Protections:Short circuit/Over load /Over voltage/Over temperature Built-in EMI filter, low ripple noise 100% full load burn-in test Fix switching frequency at 67KHz Low cost High reliability 2 year warranty SPECIFICATION MODEL DC VOLTAGE INPUT PSD-05-24 12V 0.45A CURRENT RANGE 5W RATED POWER RIPPLE & NOISE (max.) Note.2 50mVp-p 0 ~ 0.5A 5.4W 100mVp-p VOLTAGE TOLERANCE Note.3 ±2.0% ±2.0% ±2.0% LINE REGULATION ±1.0% ±1.0% ±0.5% LOAD REGULATION ±1.0% ±1.0% ±0.5% 78% 78% SETUP, RISE, HOLD UP TIME 1.2s, 20ms,--- at full load 36 ~ 72VDC VOLTAGE RANGE EFFICIENCY(Typ.) 75% DC CURRENT(Typ.) 0.15A/48V OVERLOAD PROTECTION PSD-05-12 5V 1A 0 ~ 1A 24V 0.22A 0 ~ 0.25A 5.28W 150mVp-p RATED CURRENT OUTPUT PSD-05-05 Above 105% rated output power Protection type : Fold back current limiting, recovery automatically after fault condition is removed OVER VOLTAGE 13.8~16.2V 5.75~ 6.75V Protection type : Hiccup mode, recovery automatically after fault condition is removed OVER TEMPERATURE Hiccup mode, recovery automatically after temperature goes down WORKING TEMP. -10 ~ +60℃ (Refer to "Derating Curve") 20 ~ 90% RH non-condensing WORKING HUMIDITY 27.6~ 32.4V ENVIRONMENT STORAGE TEMP., HUMIDITY -20 ~ +85℃, 10 ~ 95% RH ±0.05%/℃ (0 ~ 50℃) TEMP. COEFFICIENT VIBRATION SAFETY & EMC (Note 4) OTHERS NOTE 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes SAFETY STANDARDS EAC TP TC 004 approved WITHSTAND VOLTAGE ISOLATION RESISTANCE I/P-O/P:2.0KVAC EMS IMMUNITY Compliance to EN61000-4-2, 3, 4, 6, 8 ENV50204, EN55024, EN61000-6-1, light industry level, criteria A, EAC TP TC 020 DIMENSION PACKING 75*40*20mm (L*W*H) 50mg;120pcs/6.25Kg/1CUFT I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25℃/ 70% RH EMI CONDUCTION & RADIATION Compliance to EN55032 (CISPR32) Class B, EAC TP TC 020 1. All parameters NOT specially mentioned are measured at 48VDC input, rated load and 25℃ of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4.The power supply is considered a component which will be installed into a final equipment. All the EMC tests are been executed by mounting the unit on a 230mm*230mm metal plate with 1mm of thickness. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to “EMI testing of component power supplies.” (as available on http://www.meanwell.com) 5. The ambient temperature derating of 3.5℃/1000m with fanless models and of 5℃/1000m with fan models for operating altitude higher than 2000m(6500ft). File Name:PSD-05-SPEC 2018-01-12 PDF
Документация на PSD-05-24 

PSD-05-20180112.cdr

Дата модификации: 09.01.2018

Размер: 71.2 Кб

2 стр.

P S D - 0 5 series 5W Single Output DC-DC Converter Features : 2:1 wide input range Protections:Short circuit/Over load /Over voltage/Over temperature Built-in EMI filter,low ripple noise 3 100% full load burn-in test Fix switching frequency at 67KHz Low cost High reliability 1 year warranty SPECIFICATION MODEL DC VOLTAGE RATED CURRENT OUTPUT PSD-05-05 PSD-05-12 PSD-05-24 5V 1A 0 ~ 1A 12V 0.45A 0 ~ 0.5A 5.4W 24V 0.22A 0 ~ 0.25A 5.28W 100mVp-p 2.0% 150mVp-p 2.0% CURRENT RANGE 5W RATED POWER RIPPLE & NOISE (max.) Note.2 50mVp-p VOLTAGE TOLERANCE Note.3 2.0% LINE REGULATION 1.0% LOAD REGULATION INPUT 1.0% SETUP, RISE, HOLD UP TIME 1.2s, 20ms,--- at full load 36 ~ 72VDC VOLTAGE RANGE EFFICIENCY(Typ.) 75% 0.15A/48V DC CURRENT(Typ.) 1.0% 0.5% 1.0% 0.5% 78% 78% Above 105% rated output power OVER LOAD PROTECTION OVER VOLTAGE OVER TEMPERATURE Protection type : Fold back current limiting, recovery automatically after fault condition is removed 13.8~16.2V 5.75~ 6.75V Protection type : Hiccup mode, recovery automatically after fault condition is removed U1 Tj140 æ 27.6~ 32.4V typically(U1)Detect on main control IC ¡ WORKING TEMP. Protection type : Hiccup mode, recovery automatically after temperature goes down -10 ~ +60 æ (Refer to output load derating curve) WORKING HUMIDITY 20 ~ 90% RH non-condensing ENVIRONMENT STORAGE TEMP., HUMIDITY -20 ~ +85 , 10 ~ 95% RH 0.05%/ (0 ~ 50 ) TEMP. COEFFICIENT SAFETY & EMC OTHERS NOTE VIBRATION 10 ~ 500Hz, 2G 10min./1cycle, Period for 60min.each along X, Y, Z axes WITHSTAND VOLTAGE ISOLATION RESISTANCE I/P-O/P:2KVAC EMS IMMUNITY Compliance to EN61000-4-2, 3, 4, 6, 8 ENV50204, EN55024, EN61000-6-1 Light industry level, criteria A DIMENSION PACKING 75*40*20mm (L*W*H) 50mg;120pcs/6.25Kg/1CUFT I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22) Class B 1. All parameters NOT specially mentioned are measured at 48VDC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4.The power supply is considered a component which will be installed into a final equipment.The final equipment must be re-confirmed that it still meets EMC directives. File Name:PSD-05-SPEC 2006-08-22 PDF
Документация на серию PSD-05 

\\Fileserver-s\doc-control\do

Дата модификации: 27.10.2006

Размер: 283.3 Кб

2 стр.

    Внимание! Точность указанного на сайте описания товара не может быть гарантирована. Для получения более полной и точной информации о товаре смотрите техническое описание (Datasheet) на сайте производителя.