SPM1004-3V3C

SUMIDA Co.
Power Supply in Inductor (PSI2) Efficiency Industry leading efficiency The high performance inductor minimizes losses at full load, and the circuit topology maintains excellent efficiency over the entire load range. The next step in integration! All components integrated INSIDE inductor SUMIDA offers a new range of fully integrated power modules with outstanding performance and industryleadin...
развернуть ▼ свернуть ▲
 

Технические характеристики

показать свернуть
Выходная мощность
Количество каналов
Входное напряжение
Параметры выходов
Возможности DC-DC Regulated Power Supply Module, 1 Output, 21.78W, Hybrid
Номинальное входное напряжение
Напряжение 1 выхода
Схема параллельного включения
Сертификаты медицинские
Размер 15.2×9.2×3.2 мм
Рабочая температура
Нашли ошибку? Выделите её курсором и нажмите CTRL + ENTER

Файлы 1

показать свернуть
Power Supply in Inductor (PSI2) Efficiency Industry leading efficiency The high performance inductor minimizes losses at full load, and the circuit topology maintains excellent efficiency over the entire load range. The next step in integration! All components integrated INSIDE inductor SUMIDA offers a new range of fully integrated power modules with outstanding performance and industryleading power density. SUMIDA has leveraged its extensive experience in inductor technology to achieve the highest available efficiency as well as optimized packaging for thermal management. Benefits of PSI2 technology: • The maximum amount of magnetic material is used, rather than plastic fillers, allowing low loss and high efficiency • The coil can use thicker wire for lower resistive losses and higher efficiency • The magnetic material is thermally conductive, avoiding hot spots • The inductor provides electromagnetic shielding for the switching components • The integrated power module is fully tested and dramatically simplifies the end product design • The small size and very low profile (3 mm) package reduces board space, allowing higher density designs SPM1004 SPM1005 Thermal Over 11°C cooler, no “hot spots” The measured surface temperature is reduced by 11.5°C compared to a power module with an internal inductor under identical conditions (Figure 1). High thermal conductivity avoids "hot spots" (Figure 2). Figure 1 - Comparison Figure 2 – SPM1005 Power density High power density, up to 1600W/cu in Land Grid Array (LGA) package with a very low profile (3mm), and the footprint is only 9x15mm (SPM1004 and SPM1006) or 9x11mm (SPM1005). All major components are internal to the module, minimizing total board area for high density applications. Design time Pre-tested module simplifies your design Modules are qualified to IPC9592B standard, Class II. They are fully tested during production and are guaranteed to meet specifications. This simplifies the end product design and PCB layout, and avoids surprises during system testing. In contrast, a power design based on separate components on the end product PCB is higher risk and typically takes much longer to develop and debug. • • SUMIDA Components & Modules GmbH | Dr. Hans-Vogt-Platz 1 | 94130 Obernzell Phone: 08591/937-100 | contact@eu.sumida.com | www.sumida-eu.lcom Updated November 22, 2016 PDF
Документация на SPM1004-2V5C 

PowerPoint-Präsentation

Дата модификации: 14.06.2017

Размер: 712 Кб

2 стр.

    Внимание! Точность указанного на сайте описания товара не может быть гарантирована. Для получения более полной и точной информации о товаре смотрите техническое описание (Datasheet) на сайте производителя.